Custom Search

Friday, July 6, 2012

The 6 Easy Steps For Winterizing Utah Scooters

By Steve Smith


If you live in a seasonal place, go on a long vacation or just have to retire your scooter for some time, you will definitely need to store it correctly or there will be effects, especially with Utah scooters and mopeds with extreme conditions. Here are 6 easy steps to guarantee your scooter comes out running just as good as when you stored it or winterized it:















Winterizing Utah Scooters Step 1: Gas Tank and Carburetor


Drain the entire gas tank and spray a little WD-40 into the gas tank to prevent rust - don't go overboard. I like to drain the gas tank by running it till empty (i.e. Take it for some fun rides before the winter comes). Running it bone dry is good because it also empties the carburetor at the very same time. And that way it does not get all junked up and clogged in the winter from dust and dirt. If you decide to drain the tank, also make sure you flush the carburetor also.















Winterizing Utah Scooters Step 2: Change The Oil


Get out there and change the oil. Additionally , if you happen to have a manual transmission scooter or moped, you will want to change the oil of the clutch and gears too. This will flush out dirt and particles that may collect at the bottom of the basins. Junk, rubbish and waste can collect and will contaminate any new oil you put into the scooter in the spring.















Winterizing Utah Scooters Step 3: Engine Motor and Spark Plug


To keep the engine fresh, you can pour an especially tiny amount of two-stroke motor oil into the carburetor, and take away the spark plug and spray some WD-40 or some light weight oil into the cylinder. I repeat, very light. Pedal the engine over a couple of times to be certain the oil reaches all parts in the engine. Ensure the engine stops in the TDC position so that moisture can't enter the engine through the exhaust. Then put the spark plug back in.















Winterizing Utah Scooters Step 4: Tires and Shocks


Stand the scooter or moped up so the front and back wheel do not touch the ground. I do this by using the stand to hold the back wheel up and a bit of wood to hold the front tire up. Finish off this step by deflating the tires.















Winterizing Utah Scooters Step 5: Scooter Battery


Disconnect the battery and store it in room temperature. This is a crucial step for increasing the life of your scooter batteries. In addition, hooking up a trickle charger to your battery is far better. I'd highly recommend getting a trickle charger (only $20 BUCKS) at a local battery store. It's worth taking the few additional minutes. This can prolong the life of your battery for most likely a few years.















Winterizing Utah Scooters Step 6: Safe Storage


Store your scooter or moped indoors like a shed, garage or basement. Storing inside is a lot better than leaving it outside to be spoiled by the out of doors elements. It's no way to treat your baby! If you have got to store it outside, ensure you cover it with a solid scooter cover or at least a new tarp with no holes or wear and tear. Look after your baby. Storing Utah scooters can be coarse on them.




About the Author:



Related Posts Plugin for WordPress, Blogger...